SCOOTER / GO KART / EV BICYCLE STARTER PACKAGE
We get a lot of requests from customers putting together their own small EV vehicle, such as scooters, go carts, and EV bicycles. This is the setup we usually recommend. Just add batteries, wheels, sprockets/chains, and your frame, and you're ready to roll!


Ampflow A28-400 Motor
This is the most popular motor for small EV vehiclces mainly because of its small size, extreme power, and excellend efficiency. Typically you should use one of these per driven wheel, of course the more you use, the faster and more powerful your vehicle! See the full specifications on these motors here.


Aluminum Heat Sink Motor Mounts
Prolonged runtime of the Magmotors can cause them to really heat up. Help dissipate this heat using these heatsink motor mounts, while providing a solid mount to secure them to your frame. You should get a set of 2 to support each motor. Read more about these mounts here.

IFI Victor 885 Speed Controller
This is the speed controller that will electronically tell your motor how fast to go. Improvements in FET technology and switching technology allow the Victor 885 to handle 120A continuous. The high current capacity, low voltage drop, and peak surge capacity make the Victor 885 ideal for drive motors. Read more about this controller here.

Variable speed adjuster (servo tester)
Unless you're going to use an RC radio/receiver to control your vehicle, you need to be able to adjust the speed to your motor controller by hand. This is achieved using this "servo tester", which hooks directly to the Thor speed controller above, letting you turn the dial to adjust the speed. You can then build your own throttle control with thumb-lever or twist-grip by running a cable to the potentiometer or via other linkage. Read more about the servo tester here.


Park BEC
The Park BEC is the smallest and lightest switch-mode BEC on the market. Park BEC powers your receiver and servos much more efficiently than a standard BEC. As many as six sub-micro servos can be powered without worrying about an overheating BEC. Park BEC works great up to very high voltages, and is especially suited for running parkflyer type aircraft. Read more about the Park BEC here.


Hella Master Power Switch
You need a heavy duty power switch to connect/disconnect your batteries so that the electronics are not powered on when not in use. This switch is rated at handling 100A continuous and rush current of 1000A! Read more about this switch here.

20 feet of 10 gauge wire
You'll need some heavy duty wire for the powerful Magmotors. As long as you're not running over 5-9 feet of length, 10ga wire will do fine. You get 10 feet each of red and black (20 feet total) Read more about this wire here.
Base Price: $780

 

Building and operating an EV vehicle can be dangerous. Please use extreme caution when operating your power tools and the EV components.